Skip across the chapter
Quota Playbook

HubSpot quote checks: 5 limits to run before email

Quota Playbook Editorial Team · Published · 10 min read

Before you email a HubSpot quote, check the attachment count, the size of the quote PDF, and the total due. According to HubSpot, you can add up to 10 attachments to a quote, and HubSpot doesn't attach the generated quote PDF if it's larger than 20 MB when you share a quote by email, so check the file size before you send.

Key takeaways: the checks to run

  • attachment count: according to HubSpot, you can add up to 10 attachments to a quote, so count them before you send.
  • emailed PDF size: HubSpot doesn't attach the generated quote PDF if it's larger than 20 MB, according to HubSpot, so check the file size first.
  • signing file size: a PDF larger than 40 MB may not be successfully verified or signed, according to HubSpot, so do not treat an emailed quote as signed.
  • payment minimum: for HubSpot payments or Stripe, the total amount due must be more than $0.50, according to HubSpot, so confirm the total before you approve the quote.
  • invoice timing: according to HubSpot, subsequent invoices are generated and sent 10 days before their invoice dates under the contract's billing schedule, so put the review date on your calendar.

Review these limits together with the attachment count before the quote leaves your team.

Why quote checks belong in your review routine

Put quote checks inside the review you already run, rather than in a separate process that sellers may forget. Run the same checks in the same order each time, so a reviewer who is short on time still covers every line. A fixed order also helps new sellers learn the motion, because the same checks appear on every quote they send.

The checks below are narrow, and they cover only the limits named in the sources cited here. Scope matters because a rule from one publisher does not apply to every tool. HubSpot's attachment limit applies to quotes, according to HubSpot, so do not carry it to a proposal deck, a contract file, or an ordinary email thread.

Booking pages add a separate point. Microsoft's page titled Define your services in Shared Bookings says customers can see how much their service will cost when they book, according to Microsoft, so check any figure a buyer may see before the quote goes out. That booking-page figure does not prove how a quote is priced, so keep the two checks separate.

Before sending: attachment count and emailed PDF size

Attachment count

Start with the number of files attached to the quote, and count them on the quote itself. If the count is more than 10, remove files until it is within the limit. Review any files that are added automatically too.

Keep proposal decks, contracts and plain emails on their own review path, and note in your review notes which files were counted. A short note lets the next reviewer confirm the count without reopening every file.

If the count is at the limit, ask the seller which files the buyer needs most and move the rest to a follow-up message. This keeps the quote focused on the documents that the buyer must read before deciding. It also leaves a clear record of what was held back and why.

Emailed PDF size

The second check is the size of the generated quote PDF. Check it before you send, not after the buyer asks where the file is. If the PDF is over 20 MB, send a copy another way and say so in the email. For other file caps, see shared proposal file caps. The buyer then knows where to find the document.

Confirm the limit of any other email tool before you reuse this threshold. Write the PDF size in your notes beside the attachment count, so both file checks sit in one place.

Before payment: the total minimum and signing file size

Signing file size

The third check is the size of the PDF a buyer will sign. A PDF larger than 40 MB may not be successfully verified or signed, according to HubSpot, so treat a file over that size as one that needs a second look before it goes out.

This limit is separate from the 20 MB email limit. The 20 MB figure concerns whether an emailed quote PDF is attached, while the 40 MB figure concerns whether the PDF may be verified or signed, according to HubSpot, so record both figures.

Check the size of the PDF that comes back signed, not only the version you sent, and note the date of the check. Moving supporting material into a separate file can keep the signing document smaller, if your process allows that. Do not treat a quote that was emailed as a quote that was signed, because sending and signing are separate events.

Total minimum for payment

When HubSpot payments or Stripe is the payment processing option, the total amount due must be more than $0.50, or the equivalent minimum of the settlement currency, according to HubSpot, so confirm the total before you approve the quote.

Check which payment method the quote uses before you read the total against that figure.

Outside the checks above, a second quote changes the deal amount. According to HubSpot, if a quote with two line items that total $100 is followed by a second quote with three line items that total $150, the deal amount will be $150 and the deal will show three line items. Check the deal amount after each new quote, not only the first one. For more on deal fields, see the deal field checks guide.

Small amounts round, so expect the cent you see to differ from the raw calculation. A line item of $11.90 USD with a 15% discount applied gives a $1.785 discount, and according to HubSpot, the $1.785 discount is rounded to $1.79. Check the rounded figure rather than the raw calculation.

After sending: invoice timing and where the email lands

Invoice timing

The fifth check is when the next invoices go out. Subsequent invoices are generated and sent 10 days before their invoice dates, according to HubSpot, and the timing follows the contract's billing schedule, so put the invoice dates on your calendar.

The billing end date depends on the number of payments and the start date. The example in HubSpot's guidance, according to HubSpot, uses monthly billing with six payments starting June 1, 2025, and its billing end date falls in November. Count the payments forward from the start date before you read the end date.

Work out the billing end date for each quote before it is sent, and write both dates in your notes. Compare the start date and payment count with the contract before the quote goes out. This gives the reviewer one place to check the timing.

Where the email lands depends on the tool that holds the lead. If your team uses Close, Close attaches incoming and outgoing emails to a lead where a matching email address is present as part of the contact, according to Close, so the sent quote email should appear on the lead when the addresses match.

Open the lead after sending and confirm the quote email is there. If it is missing, compare the address on the email with the contact's address before you assume the send failed. Record the result in your notes next to the attachment count and the total.

Quote check sheet to copy into your review notes

The reference table below sets out the quoted wording for each source.

Publisher Source page Quoted wording
Microsoft Define your services in Shared Bookings "see how much their service will cost"
HubSpot Create and send quotes "You can add up to 10 attachments to a quote."
Close Email Filtering "Close attaches any incoming and outgoing emails to a lead where a matching email address is present"

Copy the lines below into your review notes for each quote. Each line refers back to a check above, so the reviewer can find the matching explanation quickly.

  • quote name, seller, and review date
  • attachment count, checked against the attachment check.
  • emailed PDF size, checked against the emailed PDF check.
  • signing file size, checked against the signing check.
  • total due and payment method, checked against the payment check.
  • invoice dates, checked against the invoice timing check.
  • lead, checked after sending.

Hold the quote until the seller fixes any line that fails.

What to keep on file after each quote review

Keep the review notes with the quote record, so the next manager can see which limits were checked. Record the attachment count, the PDF size, and the total that you saw at review, so the note matches the quote the buyer receives.

Save the link to each vendor page you relied on, so the next reviewer can see where each limit came from.

Write the date you checked each limit, so a later reviewer knows which version of the page you read. Close the review with a short line that says whether the quote was cleared to go out, and store the note with the quote.

Your next step before sending

Open the next quote you plan to email, count its attachments and PDF size, and if it uses HubSpot payments or Stripe, confirm the total is more than $0.50 before you send it. Settle the file-size and total checks before the quote leaves your team.

FAQ

How many attachments can a quote have?

You can add up to 10 attachments to a quote, according to HubSpot. Count the attachments on the quote itself before you send the quote.

What happens to a quote PDF over 20 MB shared by email?

When you share a quote by email, HubSpot doesn't attach the generated quote PDF if it's larger than 20 MB, according to HubSpot. A larger PDF should not be assumed to be attached. Send that file another way, and tell the buyer where it is.

What minimum total applies to HubSpot payments or Stripe?

When HubSpot payments or Stripe is the payment processing option, the total amount due must be more than $0.50, or the equivalent minimum of the settlement currency, according to HubSpot. Confirm the total before you approve the quote.

When are subsequent invoices generated?

Subsequent invoices are generated and sent 10 days before their invoice dates, according to HubSpot. The timing follows the contract's billing schedule, so check that schedule before you rely on the dates. Put the invoice dates on your calendar before the quote goes out.

What happens to a PDF over 40 MB that a buyer signs?

A PDF larger than 40 MB may not be successfully verified or signed, according to HubSpot. Check the size of the signed file as well, and note the result.

Where does a sent quote email appear in Close?

If your team uses Close, Close attaches incoming and outgoing emails to a lead where a matching email address is present as part of the contact, according to Close. The sent quote email should appear on the lead when the addresses match.

Sources

  1. Who is protected in pay talks: 4 facts for sales managers
  2. Equal pay for sellers: 5 official sources to compare
  3. Sales rep exit form: 8 fields for file requests and access
  4. Undo workflow changes window
  5. Bulk email timing

More plays