Before a new seller's first backup setup call, check the service license, destination space, device access, backup schedule, and key holder.
Key takeaways
- Match the service purchase details to the vendor's terms.
- Check the backup destination's current free space.
- Test access to the computer, storage, and inbound phone line.
- Record the schedule and key holder; keep unanswered schedule questions on the call agenda.
A new seller who is setting up a backup tool on a work laptop may not yet know which details matter. A call that stops to find a purchase date or a storage device uses up time for the seller and for everyone else on the line.
This post covers four checks you can make in advance. Each check states the requirement in plain words and links the page it comes from. Some rules here belong to one vendor or one product, and the post says where each one applies. None of them is a general rule for backup software. Before you rely on any point, check it against the tool your seller will actually use.
You do not need to be a backup specialist to run these checks. You need the purchase details, the laptop's storage details, a clear picture of where the backups will be kept, and a short list of questions for the seller. The sections below cover each of those in order, and each check ends with what to ask and what to do if the answer is no.
It also helps to decide before the call who on your side will answer purchasing questions, who will answer questions about the network or the laptop's permissions, and whom the seller should contact if the call is cut short. Writing those names into the note saves a search later, when the seller is waiting on an answer.
Check 1: Confirm the service license covers this setup
For Acronis Initial Setup Service, check the service license and purchase date before the call.
Acronis's initial setup page states the license rule in one sentence: "One Service license is valid for one setup session on a single machine and one mobile device." ( Acronis initial setup page) That sentence describes Acronis's service only. If the seller is using another vendor's product, look up that vendor's license terms and do not assume the same limits apply.
The same page sets a time limit: "The Service must be used within 365 days of purchase." This window applies to the setup service purchase, not the software license purchase.
The page also covers refunds, and it says: "Within 30 days of the purchase date, a full refund of Service may be requested if the Service was not used." This is Acronis's rule, and it applies to the case the sentence describes: a Service that was not used. If the setup is not going to happen soon, or the seller is not sure the tool suits the laptop, the purchase date matters for that decision.
For this check, write down four things: the vendor and product name, the purchase date, the number of licenses the seller holds, and the machine name the setup will cover. If the seller plans to connect a phone during the same session, add the phone to your notes as well.
What to ask the seller: Which product is this license for? When was it bought, and by whom? Has this license already been used for any other setup session? Which laptop is the setup for, and is a mobile device part of the plan?
If the answer is no: If the setup needs an additional machine or mobile device beyond the included allowance, or the service purchase falls outside its use window, pause the call. Pause, check the vendor's support page or ask your purchasing contact, and reschedule once you have a clear answer. A license question that is solved before the call costs far less time than one that is found during it.
Check 2: Confirm the backup destination has enough free space
Acronis's page states the space rule: "You must have sufficient space on the destination storage (an external USB drive, a NAS device, or Acronis Cloud) to perform a backup." ( Acronis initial setup page) The parenthetical names three kinds of destination. Ask the seller which one they plan to use, because the answer changes what you need to check. None of the three examples on that page is the laptop's own drive, so do not count the laptop's own storage as the destination unless the vendor's documentation says it can be used that way.
Apple gives a sizing guide for its own backup tool. On its Time Machine page, Apple says: "Use a storage device with at least twice the storage capacity of your Mac." The page also gives an example: "if your Mac has 1TB of storage, your backup disk should ideally have at least 2TB of storage." ( Apple Support, Back up your Mac with Time Machine) This is Apple's guidance for Time Machine on a Mac. It does not set a size for Acronis, restic, or any other tool. Because the page is about a Mac, it also does not tell you what a laptop running a different system needs. For other tools, ask the vendor for its own sizing guidance.
What to ask the seller: How much total storage does the laptop have, and how much of it is in use? Which destination will receive the backup: an external USB drive, a NAS device, or a cloud service? How much free space does that destination have right now?
Ask for free space, not the size printed on the box or the label on the device. A drive can be sold by its total capacity while much of that capacity is already taken, and the free space is the figure to compare against the sufficient-space requirement on that page. If the destination is a network device, ask the seller to confirm that the laptop can reach it from the work network. If your IT rules limit external drives or network shares on work laptops, find that out before the call, not after.
If the answer is no: If the free space is short, change the destination before the call rather than starting the setup and hoping it fits. Agree on a destination with enough room, confirm it, and then book the call. If the seller cannot tell you the free space, treat that as an open item, not as a yes.
Check 3: Confirm access to the computer, storage, and phone line
Acronis's page lists three requirements for the setup: "You must have access to your computer, the target storage device, and a quality telephone connection that can accept inbound calls." ( Acronis initial setup page) That is a list of three things, and the setup depends on all of them. Treat them as a checklist you go through with the seller before the call, not as details the seller will sort out while the call is running.
Start with the computer. The seller should have the laptop in front of them, charged or plugged in, and signed in with an account that can install software, if the company allows that for the account in use. If the seller does not have that permission, the setup may need to wait until someone with the right access is available. Ask about this early so there is time to arrange it.
Next is the storage device. The seller should have the destination connected or reachable before the call starts. A drive in a drawer or a NAS in another office does not help once the call begins. If the destination is a cloud service, the seller should have the account details ready and should confirm that they can sign in before the call, not during it. Ask them to check the sign-in and write down any step they are unsure about.
Then the phone. Ask the seller to test it. The simplest test is for you to call them on that line a day before the setup call, or at the start of the same morning, so you know the line rings and the seller can hear you. A line that works for outgoing calls is not the same as one that receives them, and a shared office line may route calls to someone else. Quality matters too: if the seller plans to use a mobile phone, ask them to take the call somewhere with a steady signal.
What to ask the seller: Will the laptop be with you, charged, and signed in on the day? Is the storage device connected or reachable now? Which phone line will you use, and can you take a test call from me before the setup call?
If the answer is no: Move the call. A setup call that starts with a missing device, a dead battery, or a line that cannot take inbound calls may spend its first minutes on those problems, leaving less time for the setup itself. Record which of the three items was not ready and what fixed it, so the next call starts with that item already checked.
Check 4: Confirm how far back the backups reach and who holds the keys
Before the call, confirm how far back the backups will reach and who will hold the access keys, because both affect what is kept and who can get to it.
Apple's Time Machine page gives one example of how a backup schedule can work: "Time Machine automatically makes hourly backups for the past 24 hours, daily backups for the past month, and weekly backups for all previous months." ( Apple Support, Back up your Mac with Time Machine) That schedule is Apple's, and it applies to Time Machine. It shows what a schedule can look like, not what the seller's tool will do. Ask the seller what schedule the tool uses and how long it keeps older copies, and write the answer in your notes. If the seller does not know, the vendor's documentation is the place to look, and the question should stay on the agenda for the call.
The keys are the second question. restic's documentation says: "As of version 0.9.2, restic supports both master and non-master application keys." ( restic documentation, Preparing a new repository) That sentence tells you the tool supports two kinds of key. It does not say which kind a given setup should use, and it does not describe the difference between them. If the seller's tool is restic, ask which kind of key the setup will create and who will keep it. Do not guess the answer from the name of the key type; ask the seller to confirm it against the documentation for the version they have installed.
If the seller uses another tool, ask the vendor the same two questions: what key or password opens the backups, and who holds it. The reason this matters for a manager is practical. A backup that only one person can open is harder to reach if that person is away, leaves the team, or changes roles. Knowing the answer before the call means you can plan for that case instead of learning about it later. For related account-access checks, use the backup admin checklist.
What to ask the seller: What schedule does the tool use? How long are older copies kept? Which kind of key or password does the setup create? Who will hold it, and is there a second person who can get to it?
If the answer is no: If nobody can say who holds the key, do not finish the setup on that basis. Get a named person and a documented place for the key first. Keep the key or password itself out of your notes and out of chat messages. Record that the key exists, what kind it is, and who holds it. That is enough for the next person who needs to know.
Put the four checks in one note
Send the seller a one-page note with the four checks before the call, so both of you come to the call with the same list and the same facts.
Under each check, list what to confirm:
- License: the vendor and product, the purchase date, the number of licenses, and the machine name.
- Storage: the destination type, its free space, and the laptop's total storage and how much of it is in use.
- Access: the computer, the storage device, and a phone line that has been tested for inbound calls.
- Retention and keys: the tool's backup schedule, how long older copies are kept, the key type, and who holds the key.
A setup call that starts with missing facts can end with a second call. Keep the note short. A single page that the seller can read on a phone is more useful than a long document nobody opens during the call.
On the call itself, follow the order of the note. Confirm the license first, then the destination and its free space, then the access items, and finish with the schedule and the keys. Ending on the keys gives you time to make sure someone is named as the key holder before the call closes.
After the call, file the note with the license details and the destination details. If your team keeps equipment or license records, put the purchase date and license count with them as well. The next time someone asks about this laptop or this seller's backups, the answers should be in one place rather than in someone's memory or a chat thread.
If the seller changes roles or leaves before the backups are running, the note becomes the handover. Give the next person the license, destination, schedule, and key-holder answers, and confirm that they can reach each item. That is a short job if the note was kept up to date during the call, and a long one if it was not. Use the sales record reassignment checks for the related handover.
Vendor pages change, so check the linked page again before you rely on a number from this post. When a page and this post disagree, trust the page and update your notes.
Illustrative example: an unanswered schedule question
The seller has confirmed the service purchase, destination space, device access, and key holder. The retention schedule is still unclear. The manager records that question for the setup call rather than treating it as a reason to reschedule. If the destination cannot be reached instead, the manager arranges access before booking the call again.
Your next step today
Create the one-page note now and mark each check as confirmed or needing an answer. Put unanswered schedule and retention questions on the call agenda; resolve missing access or service eligibility before proceeding.
Questions before the call
Does the setup service window apply to the software license?
No, the quoted Acronis use window applies to the Initial Setup Service purchase. Record the service purchase date separately from the software purchase details.
Should an unanswered retention question cancel the call?
No, an unanswered schedule or retention question can remain on the call agenda. Write down the question so it gets an answer during setup.
Should the note contain the backup password?
No, keep the password out of the note. Use the note to identify the key holder and the documented place for access details.