Skip across the chapter
Quota Playbook

Driver's license checks: 3 steps for seller job posts

Quota Playbook Editorial Team · Published · 12 min read

Washington permits driver's license requirements for seller jobs only when driving is an essential job function or serves the job's legitimate business purpose.

Key takeaways

  • Search every section of the posting for driver's license language.
  • Write down whether driving meets either exception.
  • Remove unsupported license requirements from postings, screening questions, and interview notes.
  • Correct a non-compliant posting promptly after notice and save a dated record.

If you write or edit seller job posts, a driver's license line is easy to carry over from an old posting without anyone deciding it belongs there. Before you publish, give it a second look. In Washington, the state's Department of Labor and Industries (L&I) has rules on driver's license requirements and job postings, and some of them took effect in 2025. This post covers 3 of them and gives you a simple check to run on every seller posting.

I am not a lawyer, so treat this as a manager's checklist, not legal advice. The 3 rules below all come from the same L&I page, and each applies in Washington only. Other states and cities may have their own rules, which I have not checked here. If you hire in other places, ask your counsel what applies there.

Washington limits driver's license requirements

L&I's Equal Pay & Opportunities Act page gives the wording for employees: "Effective July 27, 2025, employers may not require employees to have a driver's license unless driving is an essential job function or part of a job's legitimate business purpose." The same page says that, beginning July 27, 2025, employers may not require applicants to have a driver's license under the same exception.

Two points follow for a seller role. First, the question is about the job, not the title. A seller's title does not answer whether driving meets either exception, and neither does the fact that someone might occasionally take a car to a meeting. Look at what the role requires day to day. If visiting customer sites is a regular part of the work, that is a different set of facts from a role run mostly by video call. Be honest in your answer, since a rare trip described as essential driving would not match what the role actually does.

Second, the rule covers both the people you hire and the people who apply. A requirement that a seller hold a driver's license can reach the applicant at the start and the employee later on. That means the check belongs at the posting and at any screening step where a license is asked about.

Write your answer down and keep it with the role's job description. If the answer is no, take the license requirement out of the posting, out of any screening questions, and out of interviewer notes. If the answer is yes, the rule's exception applies, and your note is the record of why.

Washington limits license statements in job postings

Beginning July 27, 2025, employers may not include a statement on a job posting requiring a valid driver's license unless driving is an essential job function or part of a job's legitimate business purpose. L&I's Equal Pay & Opportunities Act page says this.

This is a second rule, separate from the first. The first is about what an employer requires of a person. This one is about the words in the posting. A posting can break this rule even if the hiring process never asks anyone for a license, because the rule is about what the posting says.

Search the whole posting, not only the requirements section. A license line can appear in a bullet list, in a nice-to-have list, or in a paragraph about the role. Search for "driver" and "license", read every hit, and check for "valid driver's license" too, since that is the wording the rule uses.

L&I has created a Job Posting Requirements factsheet (F700-225-000) to help employers understand what counts as a job posting, what information is required on job postings, and examples of postings that would meet the requirements. It is worth reading before you rewrite standard seller wording.

If the line came from a standard posting, fix that wording first. Otherwise, every new posting built from it may keep the same problem. Then go back through the postings that are already live.

If neither exception applies, remove the statement, and do not leave it in place just because it has always been there.

Washington gives employers 5 days to correct a non-compliant posting after notice

Under the complaint process on L&I's page, an employer that is given notice and an opportunity to correct a non-compliant job posting has a 5-day period to correct it. What happens next depends on whether it does. The page describes 3 outcomes:

  • If a complainant has not notified the employer of the non-compliant job posting, or it is unclear whether the employer has been given notice and an opportunity to correct it, L&I will provide the notice to the employer and confirm whether the posting was corrected within the 5-day period.
  • If the employer corrects the posting within the 5 days, L&I will notify all parties that the complaint has been resolved and close the complaint.
  • If the employer does not correct the posting within 5 days, the department can proceed with enforcement actions and may assess civil penalties.

For a manager, the lesson is speed. If you learn that a posting does not meet the rule, change it that day, and keep a dated record of the change and who approved it.

You cannot control whether someone files a complaint. You can control how fast your team reads a flagged posting, makes the change, and records it. Set a rule that a flagged posting gets fixed the same day it is found, well inside the 5 days.

Are driver's license rules the only check? No, the ADA covers hiring too

No. The ADA.gov introduction to the Americans with Disabilities Act includes hiring in its scope. The page says: "This includes things like recruitment, hiring, promotions, training, pay, and social activities."

The 3 Washington rules in this post are not a full review of a posting. A job posting is part of how you recruit and hire, so a clean license check does not make a posting clean. Ask HR or your counsel to review your standard seller posting with the ADA in mind, and ask them to look at the requirements beyond driving too. For related manager questions, see accommodation requests.

You do not need legal training to run a first pass. Read each requirement and ask whether it is needed to do the job as written. If a requirement is in the standard wording only because it has always been there, put it on the review list.

In practice, that means reading each requirement in the standard posting and asking what it measures. A requirement that screens on something other than the work itself deserves a question before it goes live. Your counsel can tell you which of those questions matter for your company.

Before you publish, run 3 checks on every seller posting

Before you publish a seller posting, search for license language, assess both driving exceptions, then remove the line or keep it with a written reason.

  1. Search the whole posting. Look for "driver" and "license" in every section, including bullets, nice-to-have lists, and the paragraph about the role.
  2. Assess both driving exceptions. Ask whether driving is an essential job function or part of the job's legitimate business purpose. Write the answer down with the job description.
  3. Remove it or keep it for a reason. If the answer is no, remove the line from the posting, the screening questions, and interviewer notes. If the answer is yes, keep your note with the job description.

Today, open one seller posting, run these 3 checks, and save the corrected version with your driving note.

What does a clean check look like?

A clean check leaves no driver's license requirement unless your note shows driving is an essential job function or part of the job's legitimate business purpose.

Put the posting, the screening questions, and the interview notes side by side, and read them together. If any one of them mentions a license without a supporting note, the check is not done. Then confirm that the note is dated and signed by the person who approved the role. Finally, save the checked version, so the next person can see what was checked and when.

Illustrative example: check one seller posting

Take a made-up posting for an inside seller role. Under the requirements, it lists "valid driver's license" next to sales experience. Run the first check, and the license line is found. Run the second check. The role is described as phone and video calls, with no customer visits. On those facts, neither driving exception appears to apply, so the license line should come out. Run the third check: remove the line from the posting, from any screening question that asks for a license, and from the interview notes. If the posting is already live, fix it that day and note the change with the date and the approver.

The example shows why the order matters. If the line is never tested against the driving question, it can stay in the posting only because it was already there. Testing it is the step that decides.

What should replace the license line?

Describe the work itself in plain words, and leave the license line out unless the driving check says it belongs.

A useful posting says what the seller does each week: who they talk to, what they sell, what tools they use, and how they work with the rest of the team. If travel is part of the role, say so and describe it. If it is not, do not hint at it with vague wording that a reader may take as a driving requirement.

What should I put in the driving note?

The note should state the job's actual driving duties, the date, and who made the decision.

Describe what the role does, not what the title suggests. For example, a note might say the role visits customer sites several times a month, or that it runs entirely by phone and video. Those facts, written plainly, are easier to check later than a general statement that driving is part of the job.

What if a hiring manager insists on the license line?

Ask for the driving duties in writing, and do not approve the line without them.

A preference for the license line is not the same as a driving duty. Ask what the seller does that requires driving, how often, and whether it can be done another way. If the answer is that the role meets either driving exception, record it and keep the line with that note. If the answer is that the line is a habit, take it out, and explain the change in one sentence.

How do I talk to a recruiter about a requirement?

Ask the recruiter for the reason behind each requirement before you approve the post.

Ask questions you can check: what does this requirement measure, and is it needed to do the job as written? If the answer is that it has always been in the standard posting, that is a reason to review it. If the answer is that it is needed for driving, ask what driving the role involves, so the note can say so. Keep the conversation short, and write down the answer.

How do I explain the change to the hiring team?

Tell them what changed, why, and what to do instead. Keep the message short and specific. Say that Washington's limits allow a license requirement or posting statement when driving is an essential job function or part of the job's legitimate business purpose, and that the team should not add a license line to a seller posting unless the check says it is needed. Point them to the L&I page so they can read the wording themselves. Explain the reason in one line, not a legal memo.

Who should own the check?

One named person should own it, and that person should sign off before any seller posting goes live.

Assigning the check to a person keeps it from falling between the recruiter who drafts a post and the manager who approves it. If you do not approve postings yourself, tell the approver what the 3 checks are and why they matter. Make the owner visible. Put the name on the posting checklist, so that anyone who asks about a post knows where to go.

When should the check happen?

Before a posting goes live, and again any time the standard wording or the role changes.

The first check happens when the post is drafted, when it is easy to fix. The second happens when the role changes, since a new duty can change the driving answer. The third is any time someone raises a concern about a posting. Keep the link to L&I's process with your correction record.

Build the check into your publishing steps rather than relying on memory. If your team already has a checklist for other posting details, add these 3 checks to it. A written step is easier to repeat than a reminder.

What mistakes should a manager avoid?

Avoid fixing only the live post, trusting standard wording without a check, and treating the 5-day window as a deadline you can miss safely.

Fixing only the live post leaves the standard wording to produce the same problem again. Trusting that wording skips the question of whether driving meets either exception for this specific role. And a manager who reads the 5-day period as slack may wait until a complaint arrives. Each mistake leaves the posting exposed in a different way, so the 3 checks cover them all.

What are the 3 rules in one place?

They are the license requirement rule, the posting statement rule, and the 5-day correction period, all from Washington's rules on the L&I page.

Keep them in front of you when you edit a seller posting. Each one is short enough to fit on an index card.

What does this post not cover?

This post covers 3 Washington points from one L&I page and one ADA point, and it does not cover other states, other cities, or every rule that may apply to a job post.

If you hire under a different state's law, or in a city with its own rules, start with that state's or city's labor agency, and ask your counsel to confirm the details. Do not assume that a rule from one place applies somewhere else.

What should I do this week?

Start with the standard wording, then check the live postings, then brief the people who approve and write them.

Standard wording is the place to make a change that reaches later postings, so do that first. Next, search every live seller posting for driver's license language and run the 3 checks on each one. Keep a short log of what you changed, when, and who approved it. Then share the checks with everyone who writes or approves seller postings, so the next new posting starts from corrected wording. Keep later hiring steps on a separate checklist, including new-seller hiring paperwork.

If you are unsure how a rule applies to your company, put the question to counsel before the next posting goes out, rather than guessing. Take the 3 checks to your next team meeting, and ask the team to bring one posting they would like reviewed.

Sources

  1. New-rep training rollout figures: 4 to read first
  2. Microsoft 365 usage: 4 windows for seller check-ins
  3. New seller pay: 3 checks before the first paycheck
  4. Track rep Duo Mobile setup
  5. Seller asks for leave checklist

More plays